Hi guys
as mentioned earlier in one of my post's i catecorized my self as "pretend to be busy" and here is what i doing on my Spare time.
This is gonna be living project and i started from my Luggage rack extra Brake lights
Took of the rack and start to figure out how to open it,,and that was not easy
got it finally open and saw the work a head,,grinding,cabling,soldering and drilling and a lot of testing, let me remind you that i have NO electrical back round, i just learning by doing and studying,, so in this project i got damages of 6 busted LED light's due the too hig voltage and not enough resistance pover, but hey, finally got it right and result was nice(at least for my eye)
Drilling the holes for 3x5mm LED lights+0.850Ohm resistor
(1edition of red leds,busted later on)
Testing that they works before soldering and after, here is latest edition of Bright Yellow leds
Then turn rack around and put then to they final position and covered them with HOT clue
Like i said cabling was challenging as available space inside the rack is minimal and lot's of grinding needed to be done.
Got them firmly in they place and yet an other test,before closing the rack
This is how it looks all assmbled
And Night view with out own LED red colour brake light
well that's done now,, next is under the bike LED installation(today and tomorrow),,2 B continue
as mentioned earlier in one of my post's i catecorized my self as "pretend to be busy" and here is what i doing on my Spare time.
This is gonna be living project and i started from my Luggage rack extra Brake lights
Took of the rack and start to figure out how to open it,,and that was not easy
got it finally open and saw the work a head,,grinding,cabling,soldering and drilling and a lot of testing, let me remind you that i have NO electrical back round, i just learning by doing and studying,, so in this project i got damages of 6 busted LED light's due the too hig voltage and not enough resistance pover, but hey, finally got it right and result was nice(at least for my eye)
Drilling the holes for 3x5mm LED lights+0.850Ohm resistor
(1edition of red leds,busted later on)
Testing that they works before soldering and after, here is latest edition of Bright Yellow leds
Then turn rack around and put then to they final position and covered them with HOT clue
Like i said cabling was challenging as available space inside the rack is minimal and lot's of grinding needed to be done.
Got them firmly in they place and yet an other test,before closing the rack
This is how it looks all assmbled
And Night view with out own LED red colour brake light
well that's done now,, next is under the bike LED installation(today and tomorrow),,2 B continue